29 December 1996. SMS. DELQA (DEQNA?) Ethernet Cabinet Kit Cable This document describes the cabinet kit for a DELQA Q-bus Ethernet interface board. The kit comprises the AUI connector and fuse assembly at the bulkhead panel, and the cable from the bulkhead panel to the DELQA board. The kit for a DEQNA was similar, and this one would probably work for a DEQNA, too. The connector at the board end of the cable is a 2x12 position, 0.1-inch pitch female. The corresponding connector on the DELQA (M7516[YM]) is a 2x10 male. The outer two pairs of hole on the female connector are unused, but the male connector accomodates the 2x12 female connector. The pin numbers shown below are for the 2x10-pin male connector on the board. The AUI connector is a DB15-S (female). The fuse on the bulkhead panel near the AUI connector is a 1.5A, 25V, slow-blow. DELQA connector, as viewed from cable end. RBK LBL VIO WH RD <-DA15 wire color 15 09 10 12 FUSE_T <-DA15 pin BN GN YL GY RD <-DEC wire color ,___________________________________, |xx 19 17 15 13 11 09 07 05 03 01 xx| <} |xx 20 18 16 14 12 10 08 06 04 02 xx| <} '~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~' VI TN BL SH OR WH BK <-DEC wire color 13 07 02 04 03 05 06 <-DA15 pin BK TL RD PN OR YL GN <-DA15 wire color ========================================= {PCB} RBK=red/black LBL=light blue VI=violet TN=tan TL=teal SH=shield PN=pink Need to bind D.04 (pink) and shield at the DELQA connector. DELQA Signal Wire color AUI (D.xx) and fuse assembly 01 Power +12V Red fuse tip 02 (nc) (missing on male, plugged on female) 03 Return 12V (nc) 04 Return 12V Blk D.06 05 Ground (nc) 06 Receive + Wht D.05 07 Receive - Gra D.12 08 Ground (nc) 09 Ground (nc) 10 Transmit + Org D.03 11 Transmit - Yel D.10 12 Ground Bare D.04 13 Ground (nc) 14 Collision + Blu D.02 15 Collision - Grn D.09 16 Ground (nc) 17 (nc) (nc) 18 (nc) Tan D.07 19 (nc) Brn D.15 20 Fuse OK Vio fuse ring fuse ring --- Org --- D.13 The cable is double shielded. "Bare" is the inner shield. The outer shield is connected to the bulkhead panel near the AUI connector. As the author (dimly) recalls, the DEQNA cabinet kit cable had one fewer wire, presumably not a very important one. AUI cable part number 70-22786-01 AMP DA15 connector parts: Post locks are AMP 5745583-5. It must be fitted to the female DB15 connector with the part number: AMP 5747845-4.